Lambert Aerodevices T2 Arrow-Shaped Flashing Position Lights COMPLETE KIT

A set of green and red strobe/position lights that act as a collision avoidance system. Designed for ultralight wings.
The set includes:

If any of the lights in the set are damaged, you can purchase a new one separately. A keel beacon can also be purchased in addition to the set.

Technical parameters

WING FLASHING LIGHTS:

Supply voltage: 9 ÷ 18 VDC
The flashing light is protected against reverse polarity of the supply voltage.
Current consumption (parking light): 0.35 A at 12 VDC
Current consumption (flashing light): 2.5 A at 12 VDC, pulsed during flashing
Power consumption (parking light): 4 W at 12 VDC
Power consumption (flashing light): 30 W at 12 VDC, pulsed during flashing
Flash repetition: 1.2 s
Dimensions: 112 × 33 × 26 mm
Weight: 59 g
Cable length: 280 mm 20 AWG

REAR FLASHER:

Supply voltage: 9 ÷ 18 VDC
The flasher is resistant to reverse polarity of the supply voltage.
Current consumption (parking light): 0.25 A at 12 V DC
Current consumption (headlight): 2.5 A at 12 V DC, pulsed on flash
Power consumption (parking light): 3 W at 12 V DC
Power consumption (headlight): 30 W at 12 V DC, pulsed on flash
Flash repeat: 1.2 s
Dimensions: 55 × 41 × 33 mm
Weight: 36 g
Wire Length: 280mm 20 AWG

Wire Markings
GND Ground
POS. Positive for Position/Navigation
STR. Positive for Strobe
SYNC Synchronization (Optional)

Installation

Mount the green beacon on the right wing of the UL aircraft. Mount the red beacon on the left wing of the UL aircraft. Mount the keel beacon on the top of the rudder of the UL aircraft. Connect the positive power wire to the POS and STROBE wires (we can connect and activate them separately or together). Also, connect the negative power wire to GND, and the SYNC signal can be connected to other beacons. If the SYNC signal is not connected, the headlight flashes will not be synchronized.

More Information

This product is not approved for installation on certified aircraft. This is not a TSO-certified light.