Reflector Landing Star T1 WW – square

Technical parameters

Power supply: 9 ÷ 15 VDC
The lamp is protected against reverse polarity of the power supply voltage
Current consumption: 1.27 A
Power consumption: 12 W
Luminous flux: 1512 lm (cool white)
Light emission angle: 25° and 10°
Built-in WIG-WAG control
WIG-WAG timing: 750/750 ms
Overheating protection
Overvoltage and undervoltage protection
Dimensions: 92 x 92 x 17 mm
Weight: 130 g

Wire identification
+12 V positive battery supply
GND ground
+SET side selection setting (left/right wing)
SYNC Wig-WAG synchronization

Shield
Connected to ground or floating.

Installation

The product has 4 holes with a diameter of 4 mm. The product can be mounted using rivets or screws up to a diameter of 3.8 mm. The product must be covered with a transparent protective glass. The metal body of the reflector can be conductively connected to the grounded parts of the aircraft or left floating. In the electrical system, 4 wires are connected: 2 for power supply (+12V; GND), 1 for side selection (left/right), and 1 for the synchronization signal between the lights.

Additional information
This product is not approved for installation on certified aircraft. This is not a TSO-certified light.